资讯中心

news center

>
  • pvc落水斗的安装?
  • 本站编辑:杭州曼布斯建材有限公司发布日期:2022-04-06 15:25 浏览次数:

在雨水槽安装位置打水平,从起始端开始到未端用墨汁弹线。

从包装袋中取出雨水槽,将雨水槽平稳的放在地上或脚手架上,并在雨水槽下水平装雨水斗的位置,用

切割机切一个与雨水斗下水口一样大小的口子。

将雨水斗缓慢插入雨水槽至下水位置。

在雨水槽上安装吊接器;按顺序插入并掌握好间距,两只相邻吊接器之间的距离为40~45CM;

用电钻(6号钻头)在弹线位置按40~45CM的间距打好洞,并敲进膨胀管。

将雨水槽放置在已弹线位置,调整好“吊接器”间距,然后用∮4X40的不锈钢镙丝将吊接器和雨水槽固定。

遇上雨水槽转角,需用“卡接器”连接“阳角”、“阴角”,雨水槽与雨水槽连接部分也需用“卡接器”连接。

雨水槽安装的过程中,为防止漏水,锁毕器、卡接器等相应的配件上必需打上玻璃胶和PVC胶水。

Level the installation position of rain gutter, and snap the line with ink from the starting end to the end.

Take out the rain gutter from the packing bag, put the rain gutter on the ground or scaffold stably, and install the rain bucket horizontally under the rain gutter

The cutter cuts a hole the same size as the drain of the rainwater bucket.

Slowly insert the rain water bucket into the rain water tank to the water discharge position.

Install the hanger on the rainwater tank; Insert in sequence and grasp the spacing. The distance between two adjacent hangers is 40 ~ 45cm;

Use an electric drill (No. 6 drill) to drill holes at the line snapping position at a spacing of 40 ~ 45cm, and knock into the expansion pipe.

Place the rain gutter at the snapped line position, adjust the spacing of "hanger", and then fix the hanger and rain gutter with ∮ 4x40 stainless steel screws.

In case of corner of rainwater tank, it is necessary to connect "external corner" and "internal corner" with "adapter", and the connecting part between rainwater tank and rainwater tank also needs to be connected with "adapter".

During the installation of rain gutter, in order to prevent water leakage, glass glue and PVC glue must be applied to the corresponding accessories such as lock and connector.

客服热线
18989876872